Abstract: Because of internal circuit-breaker delay and limited MOS-gate pulldown current, many hot-swap controllers do not limit current during the first 10µs to 50µs following a shorted output. The result can be a brief flow ...

Abstract: This application note describes a circuit that protects an n-channel power MOSFET against low and high voltages. It includes a high-side switch-driver IC and fast-response, 3-transistor, overvoltage detector. Vo...

Abstract: Substituting a shunt regulator (U1) for the usual transistor in this power-amplifier circuit improves the current-limit accuracy. Adding current-limiting circuitry to an emitter follower protects both the pass t...

Abstract: Simple easy to use high side current sense amps protects power supplies as a result of irregular supply voltage caused by short-circuit conditions. To ensure compliance with all international standards, the desi...

電源故障保護布局-P...

Abstract: Residual phase noise from local oscillators (LO) can be degraded by additive noise of on-chip local oscillator drivers/buffers in integrated circuit mixers. Reciprocal mixing of strong RF signals with the LO noise degrades the re...

Abstract: An isolated transformer-driver IC (MAX845) and small external transformer produce an isolated gate-control signal for a power FET. Designers of power electronic circuits must often drive power switches that feed...

摘要：DS3984, DS3988, DS3881, DS3882, DS3992和DS3994為冷陰極熒光燈(CCFL)控制器，它們使用推挽結構來產生驅動熒光燈所需的高壓交流波形。在推挽式驅動器中，升壓變壓器的寄生電感與n溝...

摘要：本應用筆記說明如何對MAX2010 (可調節RF預失真器)標準評估板進行下蓋，使其工作頻率優化在450Hz。默認情況下，預失真器工作在500MHz至1000MHz，但是，對MAX2010評估板稍做修改，...

摘要：本應用筆記說明如何對MAX2010 (可調節RF預失真器)標準評估板進行下蓋，使其工作頻率優化在360Hz。默認情況下，預失真器工作在500MHz至1100MHz，但是，對MAX2010評估板稍做修改，...

摘要：DS1870用于射頻(RF)功率放大器偏置控制，如果不接外部電阻，采用5V基準，其偏置電壓范圍為3V至5V。本應用筆記旨在展示如何利用外接電阻達到適當?shù)姆秶头直媛省？梢岳?..

摘要：LDMOS RF功率放大器因其極高的性價比在GSM和CDMA基站市場占據了主導地位。使用LDMOS放大器時，保證高性能的一個關鍵因素是補償柵極偏置電壓，以在溫度變化時保持恒定的靜態...

A digitally adjustable voltage reference is useful in many applications. For instance, it can be used to finely tune the reference voltage when absolute accuracy is required or to adjust the reference voltage to match the full-scale voltag...

There are many portable applications that optimize circuit performance by adjusting the output voltage of a DC-DC converter. For instance, many microprocessors can operate at a low voltage to save power, and then operate at a high voltage ...

Abstract: This application note describes how to use a digital potentiometer to generate an adjustable voltage supply using a MAX1776 step-down DC-DC converter. A reference design using the DS3903 is shown that features the ability to prod...

摘要：本文闡述了如何使用DS1841對數電位器調節APD偏置電路的輸出范圍。為了使調節過程更簡單，本文還提供了電子數據表。 APD偏置電路DS1841可受溫度控制的...

Abstract: This circuit, which uses a digital potentiometer (pot) and a comparator, features droopless operation that is not normally associated with peak detectors that have traditionally used rectifiers and sample-and-holds (S/H). ...

Abstract: This article discusses application circuits for Maxim force/sense digital-to-analog converters (DACs). Applications include: selectable fixed-gain DAC, programmable gain DAC, photodiode bias control, amperometric sensor control, ...

Abstract: The MAX4172 IC substitutes a current amplifier for the shunt normally associated with a moving-coil meter. This circuit allows use of the moving-coil meter, even when the meter current is a large fraction of the current being mea...

摘要：許多裝置需要一個用戶接口來調整溫度、背光強度和電源電壓等，這個用戶接口需要能夠避免按鍵調整中的誤操作。若在這些裝置中使用一個數字電位器，設計人員可以通過...